top of page

1973–87 Chevy C/K Square Body: What to Check Before You Start a Build

Oct 15
3 min read

Chevrolet introduced the Square Body era for 1973. On these trucks, C means two-wheel drive and K means four-wheel drive. Most builders use “1973–87” as shorthand for the C/K pickups, while Chevrolet’s own history notes that updated versions of the body continued through 1989.

That long run gives you plenty of ways to build one, but it also makes it easy to order parts before the plan is settled. Start with the truck in front of you, not the finished truck in your head.

Confirm What You Have

Write down the year, C or K model, wheelbase, current brake setup, steering setup, engine, transmission, rear axle, and wheel size. Check the frame, cab mounts, bed mounts, crossmembers, and the area around the steering box before spending money on paint or power.

A clean parts list starts with a clean inspection. Rust, old repairs, swapped axles, and previous-owner changes can matter more than the badge on the fender.

Choose the Stance Before You Buy Parts

Decide whether the truck is staying stock height, getting a mild drop, or going low. That choice affects the suspension parts, shocks, wheel and tire clearance, steering geometry, and brake plan.

Matched kits take guesswork out of the job. Mixing individual parts can work, but only when every piece is chosen for the same truck and the same finished ride height. Do not build the front suspension around a wheel or tire you have not measured.

Treat an LS Swap as a System

An LS swap is more than engine mounts. Chevrolet Performance’s own swap material calls out the rest of the package: mounts or adapter plates, transmission mounting, wiring, engine management, and the supporting parts that make the engine run in the new chassis.

On a Square Body, plan the oil-pan and crossmember clearance, accessory drive, transmission location, fuel system, cooling system, wiring and controller, exhaust routing, and service access before ordering. One missed clearance can turn a bolt-in plan into a fabrication job.

Build in the Right Order

Start with the structure, steering, and brakes. Set the stance next. Then mock up the engine and transmission before finishing the fuel, cooling, wiring, and exhaust systems. Paint, trim, and engine-bay details come after the hard parts fit.

That order is not flashy, but it keeps you from redoing finished work. A truck that stops, steers, clears, and can be serviced is a better foundation than a pile of parts bought out of order.

Make the Shopping List Specific

Before you place an order, put these facts on one page:

  • Year and C or K model

  • Wheelbase and cab/bed configuration

  • Current brakes and steering

  • Target ride height

  • Wheel diameter, width, and backspacing

  • Engine and transmission

  • Parts already installed

  • Jobs that require fabrication

That sheet makes it easier to compare complete kits, catch missing pieces, and avoid buying the same part twice.

Build the Truck You Will Use

A Square Body can be a work truck, a low cruiser, an LS-swapped driver, or a clean show build. Pick the job first. Then spend money on the parts that move that job forward.

Vintage Rust is building its parts catalog around LS swaps, lowered classic trucks, and the hardware that belongs in a real garage. Browse Vintage Rust parts, or subscribe to Garage Notes for practical build planning and new-product updates.

Sources

Comments


Vintage Rust classic truck apparel brand logo — C10 F100 patina garage lifestyle

Subscribe and get a one-time 10% off apparel, merch, coffee and tea. Excludes parts.

​If it’s bagged or sitting on billets, it belongs here. Vintage Rust builds apparel and gear for the slammed-truck crowd — C10s, F100s, D100s, and anything dragging frame.

  • TikTok
  • Instagram
  • Facebook
bottom of page